Answer:
Explanation:
Cylinder P is taller than cylinder Q. In fact, it's twice as tall. So if cylinder Q is, let's say, 10 inches tall, cylinder P would be 20 inches tall.
Cylinder P is also wider, but not by a lot. It's only half as wide as cylinder Q. So if cylinder Q has a width of 10 inches, cylinder P would have a width of 5 inches.
Now, let's talk about the insides of these cylinders, how much stuff they can hold. If we filled them up with something, like water, the bigger one (cylinder P) can hold twice as much as the smaller one (cylinder Q).
So, cylinder P can hold more stuff because it's both taller and a little wider than cylinder Q.
Answer: Minerals that are mined for titanium are ilmenite and rutile.
Explanation:
Titanium is the 22nd element of the periodic table. It symbol is "Ti"
The minerals which are mined to extract titanium are ilmenite and Rutile
Titanium is extracted from ilmenite with a process of acid leaching using fluorosilicic acid
Titanium is extracted from rutile by converting it into titanium(IV) chloride, and then reducing it to titanium using either magnesium or sodium.
Therefore, Mineral that are used to mine Titanium are ilmenite and rutile.
The given system is a constant pressure systemwhere the work done is the product of the pressure and the volume change.
Reasons:
Given parameters;
The original volume, V₁ = 40 cm³
The energy released, E = 950 J
Constant pressure applied, P = 650 torr.
Condition: All energy is converted to work to push back the piston
Required:
The volume to which the gas will expand
Solution;
The work done, W = Energy releases, E = 950 J
Work done at constant pressure, W = P·(V₂ - V₁)
Where;
V₂ - The volume to which the gas will expand
Converting the volume to from cm³ to m³ gives;
V₁ = 40 cm³ = 0.00004 m³
Converting the pressure given in torr to Pascals gives;
650 torr. = 86659.54 Pa.
Therefore, we get;
950 J = 86659.54 Pa. × (V₂ - 0.00004 m³)
Converting to liters gives;
Learn more here:
Answer:
Explanation:
Given :
Initial volume Lit.
Energy J = 9.38 Lit × atm. ⇒ ( 1 Lit×atm. = 101.325 J )
Pressure 650 torr = 0.855 atm. ⇒ ( 1 torr = 0.00132 atm )
In this example we have to be aware of unit conversion system.
From the laws of thermodynamics,
Here in this example, all the energy of combustion is converted into work to push back the piston
Lit =
20m is the right answer on plato!!
while a wave is propagating through a single media
when two waves moving in opposite directions collide
none of the above
Answer:
The correct answer is actually "at boundaries between two different media"
Explanation:
Checked and it is said word for word in the corresponding slide