Sludge and water mixture is homogeneous or heterogeneous mixture?

Answers

Answer 1

Answer:

Answer:

It is a heterogeneous mixture

Explanation:

A mixture is a substance that is formed by several components (two or more), which do not lose their properties and characteristics due to the mixing because there is no chemical reaction between them.

Homogeneous mixtures: Those mixtures whose components cannot be distinguished with the naked eye. The homogeneous mixtures of liquids are known as solutions and consist of a solute and a solvent, the first being the one in smaller proportion and also usually the liquid. For example, water mixed with mineral salts or sugar, water would be the solvent and sugar the solute.

Heterogeneous Mixtures: A heterogeneous mixture is one that has a non-uniform composition in which its components can be distinguished with the naked eye and is formed by two or more substances, physically different, unevenly distributed. The parts of a heterogeneous mixture can be separated mechanically. For example, water and sand, water and sludge, water and oil

Related Questions

What is the isoelectric point of proteins?
. An open manometer is filled with mercury. The mercury level is 12mm higher on the side open to the atmosphere. What is the total pressure of the gas, in kPa, if the atmospheric pressure is 100.8 kPa?
What is the answer? Please
PromptDescribe the general process by which new elements are synthesized.Please help!!!!
A solution of salt and water is 33.0% salt by mass and has a density of 1.50 g/ml. what mass of the salt in grams is in 5.00l of this solution?

What is the only gaseous component of the atmosphere whose concentration is routinely contained in all weather reports?

Answers

In weather report generally the temperature conditions and the extent of humidity is described. Humidity is nothing but presence of water in its vapour form. Hence the only gas which is being reported in a weather report must be water vapour. The other gases like oxygen carbon dioxide or noble gases or nitrogen are never mentioned in a normal weather report issued in public interest

Wich substances is most likely to form in a precipitation reaction?

Answers

Answer:

A precipitation reaction refers to the formation of an insoluble salt when two solutions containing soluble salts are combined. The insoluble salt that falls out of solution is known as the precipitate, hence the reaction's name.

Explanation:

Movement of earths tectonic plates appears to be caused by

Answers

Answer: The force that causes most of the plate movement is thermal convection, where heat from the Earth's interior causes currents of hot rising magma and cooler sinking magma to flow, moving the plates of the crust along with them. ... In ridge push and slab pull, gravity is acting on the plate to cause the movement

Select the complexes that exhibit geometric isomerism. check all that apply. check all that apply. [co(h2o)2(ox)2]− [co(h2o)2(nh3)2(ox)]+ [co(en)3]3+ [ni(co)2cl2] [ni(nh3)2(en)2]2+

Answers

Geometric isomerism in another name is called cis-trans isomerism or it is called E-Z isomerism.
[Co(H2O)2(ox)2]- it is an octahedral complex which has two of bidentate ligand and another two of ligand. It exists as cis-trans isomers.
[Co(en)3]³+ it is an octahedral complex which has three bidentate ligands and it cannot exist as cis-trans isomers.
[Ni(CO)2CL2] is a square planar complex which has two of one ligand another two of ligand. It exists as cis-trans isomers.
[Co(H2O)2 (NH3)2(ox)]+ it is an octahedral complex with one of bidentate ligand two of each another ligand. It exists as cis-trans isomers.
[Ni(NH3)2 (en)2]²+ is an octahedral complex with one of a bidentate ligand and two each of another ligand. It exists as cis-trans isomers.
Following compounds exhibit geometric isomerism.
[Co(H2O)2 (ox)2]-
[Co(H2O2) (NH3)2 (ox)]+
[Ni(Co)2 CL2]
[Ni(NH3)2 (en)2]²+

Show the conversion factor from Patolbf/ft2is 0.02089.

Answers

Explanation:

1 Pascal = 1 N/m²

To convert Pa to lbf/ft²

So, the conversion of N to pound force (lbf) is shown below as:

1 N = 0.224809 pound force (lbf)

The conversion of m² to ft² is shown below:

1 m² = 10.7639 ft²

So,

[tex]1\ Pa=\frac {1\ N}{1\ m^2}=\frac {0.224809\ lbf}{10.7639\ ft^2}

1 Pa = 0.02089 lbf / ft²

Hence proved.

What are four properties of water?

Answers

Answer:

Polarity

Cohesion

Adhesion

High Specific Heat

Explanation:

Other Questions

Explain what the police siren sounds like to Jane. Explain what the police siren sounds like to John. Explain why the police siren sounds different between Jane and John.

The activiation energy required for a chemical reaction can be decreased by? A) increasing the surface area of the reactant. B) increasing the temperature of the reactant. C) adding a catalyst to the reaction. D)adding more reactant

What is a characteristic of property acids pls help

C6H6NCl On the basis of the molecular formula, 1H NMR data, and IR data provided, propose a consistent structure.H`NMR data: δ 300 (s, 2H), 6.57 (d, 2H), 7.05 (d, 2H) IR data: 3400 (broad), 3250 (broad), 1590, 820 cm^(-1).Draw your proposed structure below.