Answer:
hsu589 quip 2hciq93hgshqueo
To leg up a platform in set construction, 2 by 4s are typically used as legs that fit under the platform and bolted to the 2 by 4s. The legs must be the same height for balance and stability. If the platform is tall, extra strength or support like L-shaped legs is recommended.
One of the most common ways to leg up a platform in set construction is to use 2 by 4s as legs. First, cut four legs to the height of your platform, minus half of an inch. The legs fit up under the platform, and are bolted to the 2 by 4 feet of the platform. It's crucial that all legs are the same height, maintaining the balance and stability of the platform. For tall legs or platforms, more than 5 or 6 feet high, it's advisable to screw two 2 by 4s together, increasing the strength to support the platform efficiently. Using sturdier lumber to frame your platform is also a smart move, such as using 4 by 4s instead of 2 by 4s. Drill holes through the 2 by 4s into the center of each leg and ensure they're plumb. Use a drill bit slightly smaller than the bolt you are going to use, typically 3/8 inch or 5/16 inch carriage bolts that are at least five inches long. After drilling the holes, fasten the bolts using a wrench, accompanied by a washer and hex nut. If the legs stand taller than 72 inches, additional support like diagonal braces may be necessary. More specifically, L-shaped legs, which are two 2x4 legs screwed together and positioned directly under the platform, can provide extra support.
#SPJ3
b. organic
c. three-dimensional
d. geometric
This element is often said to be dominant and is often a focal
point in the artwork.
Answer:
Point of interest
Explanation:
Or focal point