Federal Law mandates that the steering or helm area of a power boat less than 20 feet in length must have which of the following?a. Latex gloves.b. Capacity Plate.c. Ladder stand.d. Rear

Answers

Answer 1

Answer:

Answer:

b. Capacity Plate.

Explanation:

According to the Federal Law, boats of less than 20 feet in length need to have a capacity plate that has to be in the steering area all the time. Also, this capacity plate has to show the maximum people capacity, weight and horsepower recommended. Because of this, the answer capacity plate.

Answer 2

Answer:

Answer:Federal Law mandates that the steering or helm area of a power boat less than 20 feet in length must have Capacity Plate. The correct option is B.

Explanation: The capacity Plate indicates the maximum weight capacity and/or the maximum number of people that the boat can carry safely in good weather. Information on the capacity Plate includes the maximum number of adult persons, the maximum gross load, and the maximum size of engine, in horsepower,

Related Questions

Which of the following is a characteristic of elements A. They are always metalsB. They cannot be divided into simpler substances C. They break down when reacting with acids D. They can be altered with and electric current
Which spectral class does the sun belongs to
The blood pressure in human body is greater at the feet than the brain
The right-hand rule may determine the direction of magnetic force, conventional current, or the magnetic field as long as two of these directions are known. True or False?
A hobo hops a freight train traveling at 2.5 m/s due east. The man boards the train from the rear of the boxcar and walks from the southwest corner to the north east corner of the car at a rate of 5.0 m/s. The boxcar is 15 meters long and 3 meters wide. What is the velocity of the man relative to the train tracks?

Anthony walks to the pizza place for lunch. he walk 1 km east, then 1 km south and then 1 km east again. what distance did he cover? what was his displacement?

Answers

he covered an amount of 2 km to east and one to south. the displacement, yeah i dont have that sorry :[

Which of the following does not accurately depict a scientific theory?A. Theories are tested over and over again.
B. Theories are supported in many ways.
C. Theories may be changed or replaced if new evidence is found.
D. Theories are absolute truths.

Answers

Scientific theories are not absolute and unquestionable truths: they are the best explanation of the data, but they can be challenged if new data is discovered or if a new theory is found that fits to and explains the data even better!
The best answer is d: this is not an accurate description of a scientific theory!

A student releases a block of mass m at the top of a slide of height h1. the block moves down the slide and off the end of the table of height h2, landing on the floor a horizontal distance d from the edge of the table. Friction and air resistance are negligible. The overall height H of the setup is determined by the height of the room. Therefore, if h1 is increased, h2 must decrease by the same amount so that the sum h1+h2 remains equal to H. The student wants to adjust h1 and h2 to make d as large as possible.A) 1) Without using equations, explain why making h1 very small would cause d to be small, even though

h2 would be very large?
2) Without using equations, explain why making h2 very small would cause d to be small, even though
h1 would be large

B) Derive an equation for d in terms of h1, h2, m, and physical constants as appropriate.

Answers

(A)

(1) The reason for making $h_(1)$ very small is due to smaller value of horizontal component of launch velocity.

(2) The reason for making $h_(2)$ very small is due to smaller value of time of flight.

(B) The distance (d) covered by the block is $2\sqrt{h_(1)h_(2)}$ .

Given data:

The mass of block is, m.

The height of table from the top of slide is, $h_(1)$ .

The height of table at the end of slide is, $h_(2)$ .

The height of room is, H.

(A)

(1)

If the launch velocity of the block is v, then its horizontal component is very small, due to which adjusting the height $h_(1)$ to be very small will cause the d to be small.

(2)

The height $h_(2)$ is dependent on the time of flight, and since the time of flight taken by the block to get to the floor is very less, therefore the block will not get sufficient time to accomplish its horizontal motion. That is why making $h_(2)$ very small will cause d to be smaller.

(B)

The expression for the distance covered by the block is,

$v=(d)/(t)\nd = v * t$ ..............................(1)

Here, v is the launch speed of block and t is the time of flight.

The launch speed is,

$v^(2)=u^2+2gh_(1)\nv=\sqrt{u^2+2gh_(1)}\nv=\sqrt{0^2+2gh_(1)}\nv=\sqrt{2gh_(1)}$

And the time of flight is,

$h_(2)=ut+(1)/(2)gt^(2)\nh_(2)=0 * t+(1)/(2)gt^(2)\nh_(2)=0+(1)/(2)gt^(2)\nt=\sqrt(2h_(2))/(g)$

Substituting the values in equation (1) as,

$d = v * t\nd = \sqrt{2gh_(1)}* \sqrt(2 h_(2))/(g)}\nd=2\sqrt{h_(1)h_(2)}$

Thus, the distance (d) covered by the block is $2\sqrt{h_(1)h_(2)}$ .

Learn more about the time of flight here:

brainly.com/question/17054420?referrer=searchResults

A1) The reason why making h₁ very small would cause d to be small is; Because the horizontal component of the launch velocity would be very small.

A2) The reason why making h₂very small would cause d to be small is;

Because the time of flight it will take the object to get to the floor would be very small and as a result, the object would not possess enough time to move horizontally before the vertical motion.

B) The equation for d in terms of h₁ and h₂ is;

d = 2√(h₁ × h₂)

A) 1) The reason why making h₁ very small would cause d to be small is because the horizontal component of the launch velocity would be very small.

A) 2) The reason why making h₂ very small would cause d to be small is because the time of flight it will take the object to get to the floor would be very small and as a result, the object would not possess enough time to move horizontally before the vertical motion.

B) Formula for Launch Velocity is;

V = √(2gh₁)

h₁ was used because the top of the slide from where the student released the block has a height of h₁.

Also, the time it takes to fall which is time of flight is given by the formula;

t = √(2h₂/g)

h₂ was used because the height of the table the object is on before falling is h₂.

Now, we know that d is distance from edge of the table and formula for distance with respect to speed and time is;

distance = speed × time

Thus;

d = √(2gh₁) × √(2h₂/g)

g will cancel out and this simplifies to give;

d = 2√(h₁ × h₂)

Read more at; brainly.com/question/20427663

The perspective that focus's on human growth and flourishing. Based on Abraham Maslow's Hierarchy of Needs and self actualization.Group of answer choices

social/cultural

behavioral

biological

humanistic

Answers

The perspective that focuses on human growth and flourishing, based on Abraham Maslow's Hierarchy of Needs and self-actualization, is known as:

Humanistic

What storm causes flash floods?
Tornado
Thunderstorm
Hurricane

Answers

Answer:

hurricane.

Explanation:

............................

Which describes the characteristics of a liquid?a. It has no fixed volume or shape.
b. It has a fixed volume and shape.
c. It has high energy and expands to fill the container.
d. It has a fixed volume and varied shape.

Answers

What happens when you pour water in a glass? It takes the shape of the glass. This means that water can't have a fixed shape or volume

Other Questions

When two notes are played simultaneously creating a discordant sound, it is called ______

The function f(x)equalsnegative 0.25 (x minus 2 )squared plus 8 models the path of a volleyball when the player is 2 feet from the net. The height of the net is 7 ft comma 4 in. Will the ball go over the net? What if the player moves back so she is 4 feet from the net? Explain.

When looking at human motives the following theorist developed a hierarchy of five needs that range from basic physiological needs to groeth or meta-needs

What is the unit of work? Explain whether the unit of work is a fundamental uintor derived unit1.What do you mean by a unit?2.unit or a derived unit.are the fundamental units used in physics?al Bureau of Weights and Me