Answer:
Explanation:
Hello,
In this case, it firstly necessary to understand how the complete (100%) dissociation of the potassium phosphate is done:
In such a way, since the freezing point depression and the boiling point elevation are computed as:
The corresponding van't Hoff factor is four as 3 potassiums and 1 phosphate as ions are obtained during the dissolution. In addition, the freezing point depression constant and boiling point elevation constant of water are 1.86 and 0.512 °C/m respectively. Moreover, the freezing point of water is 0 °C and the boiling point is 100 °C, therefore, the resulting freezing and boiling temperatures for the 2.59 m solution of potassium phosphate are:
Best regards.
Answer:
The inert pair effect is the tendency of the two electrons in the outermost atomic s-orbital to remain unshared in compounds of post-transition metals. The term inert pair effect is often used in relation to the increasing stability of oxidation states that are two less than the group valency for the heavier elements of groups 13, 14, 15 and 16. .[1] The name suggests that the outermost s electrons are more tightly bound to the nucleus in these atoms, and therefore more difficult to ionize or share
Answer:
I think the best answer is migration. In an alpine biome, animals have two problems which is the very cold temperature and the UV rays from the sun. Most alpine animals hibernate and migrate to warmer areas of the mountains when the temperature continues to drop.
2. Cap the syringe tightly.
3. Pull the plunger back to double the volume of gas in the syringe.
Which best describes the purpose and outcome of the demonstration?
Since you couldn't even put the answer choices down, i'll give the unfortunate viewers who are confused, the answer.
It is C) Boyle's law since it is showing the relationship between pressure and volume.
Are the products or reactants favored?
The equilibrium system N2O4(g) 2NO2(g) was established in a 1.00-liter vessel. Upon analysis, the following information was found: [NO2] = 0.500 M; [N2O4] = 0.0250 M. What is the value of Keq?
3.Which is the correct expression for Keq when the chemical reaction is as follows:
N2 + 3H2 2NH3.
4.Reactions which do not continue to completion are called ______reactions.
Answer: 1)
Equilibrium constant is defined as the ratio of the product of concentration of products to the product of concentration of reactants each term raised to their stochiometric coefficients.
where [] = concentration in Molarity=
Thus
As the value of K is greater than 1, the reaction is product favored.
2)
3)
4) Reactions which do not continue to completion are called equilibrium reactions as the rate of forward reaction is equal to the rate of backward direction.