The feedback the other lab group should give is (d) the line of best fit is not reasonable because it has more points below it than above it.
From the scattered plot (see attachment), we can see that the scattered plot has a total of 7 dots,
There are more points below the scattered plot, than above it.
This means that the scattered plot is not reasonable because of (d)
Read more about scattered plots at:
Answer:
The correct option is;
The line of best fit is not reasonable because it has more points below it than above it.
Step-by-step explanation:
Here we note that there are a total of seven points in the scatter plot and there are five of the points below the line of best fit and just two above the line.
Of the five points below the line of best fit, four are just about touching the underside of the line while one of the two points above the line is just about touching the line.
The proper positioning of the line can be reviewed, therefore, with a line drawn through the four points presently touching the underside of the line of best fit.
For this case, we will use the simple interest formula:
Where,
Therefore, replacing values we have:
Answer:
The simple interest is given by:
$
(x – 3)(x – 15)
(x + 3)(x + 15)
(x – 3)(x + 15)
The value of x that satisfies the equation 0.3x = 12 is 40.
We have,
To find the value of x in the equation 0.3x = 12, we need to isolate x on one side of the equation.
We can do this by dividing both sides of the equation by 0.3, which will cancel out the coefficient of x on the left side:
(0.3x) / 0.3 = 12 / 0.3
Simplifying this equation gives:
x = 40
Thus,
The value of x that satisfies the equation 0.3x = 12 is 40.
Learn more about equations here:
#SPJ6
Answer:
You divide 0.3 by 12 if you don’t want a decimal do it the other way around the answer is x=40
Step-by-step explanation:
(x − 3)^2 = 2
(x − 2)^2 = 1
(x − 1)^2 = 4
Can anyone show the steps on how to get the answer?
Answer:
Assuming the shape is a half-circle, there's two right angles.
Step-by-step explanation:
The angle between the straight segment and the half-circle can be measured by taking a tangent line at the intersection point and it will of course be perpendicular to the straight segment, assuming the segment is the diameter of the circle).