PHYSICS HIGH SCHOOL

The photo shows a simple electric circuit.Which part of an electric circuit resists the flow of charge when it changes electrical energy into other forms of energy?



A.
part B - copper wires

B.
part A - battery

C.
part C - switch

D.
part D - lightbulb

Answers

Answer 1
Answer: The part of an electric circuit that resist the flow of charge when it changes electrical energy into other forms of energy would be : D. Lightbulb
It convert electrical energy into heat and light energy, which resist the flow of charge during the process

hope this helps
Answer 2
Answer:

Answer: I know this is from 2016 but I am going to confirm that it is in fact D - Light bulb

Explanation: I took the test in K-12.

Related Questions

Carlos gets tired of pushing and instead begins to pull with force Fpull at an angle to the horizontal.The block slides along the rough horizontal surface at a constant speed. A free-body diagram for thesituation is shown below. Blake makes the following claim about the free-body diagram:Blake: “The velocity of the block is constant, so the net force exerted on the block must be zero.Thus, the normal force FN equals the weight Fmg, and the force of friction Ff equals the appliedforce Fpull.”What, if anything, is wrong with this statement? If something iswrong, identify it and explain how to correct it. If this statement iscorrect, explain why.
One consequence of Einstein's theory of special relativity is that mass is a form of energy. This mass-energy relationship is perhaps the most famous of all physics equations: E=mc2, where m is mass, c is the speed of the light, and E is the energy. In SI units, the units of speed are m/s. For the preceding equation to have consistent units (the same units on both sides of the equation), the units of E must be which of the following?
How do I calculate the equivalent resistance?
Air is warmed and moisten as it moves through both the mouth and nasal passages.a. Trueb. False
What form of energy transforms to what other form when you turn on a steam iron?

What is an astronomical unit?the average distance between planets in the solar system
the average distance between the Earth and the moon
the approximate diameter of the Sun including its atmosphere
the average distance between the Earth and the Sun

Answers

Answer:

D

Explanation:

Select all the factors listed that influence the density of ocean water.a. tides
b. salinity
c. fecundity
d. temperature E. wave height F. current speed

Answers

Answer: b and d

Explanation:

I don’t really have an explanation I just took the test and this was the answer good luck

Select all that apply. _____ is a place where the crust of the lithosphere has fractured. A fault A subduction zone An oceanic trench A river

Answers

A fault? yes !A fault is a fracture with a significant rock mass movement as a result.


 A subdution zone? No, although it is a place where the tectonic place meet (so are likely to fracture, but do not necessarily need to fracture).
 
An oceanic trench? No, although a trench does mark where the tectonic plates meet

A river? no!

The only right answer from these available options is a fault.

The first American to orbit the earth was:Frank Borman
Buzz Aldrin
Neil Armstrong
John Glenn

Answers

John Glenn is the first American to orbit the Earth.

♡♡Hope I helped!!! :)♡♡

Yes, John Glenn was the first to orbit the earth but the question I read was who WALKED ON THE MOON.....the answer to who was the FIRST to walk on the moon... is  Neil Armstrong but Buzz Aldrin also walked and was there with Armstrong but wasn't the first.  You have to be careful about the astronaut 'firsts'.  Alan Shepherd was the first in space....John Glenn was the first to orbit the earth....Edward White was the first to 'walk in space' and Neil Armstrong was the first man to walk on the moon. Also remember that all of these were American Astronaut firsts.  The Russians actually put up the first man in space.  Yuri Gagarin was the first man.  Buzz Aldrin landed and walked on the moon also.

Although the Bohr atomic model is helpful in counting electrons in their orbitals, why is this model inaccurate in terms of the actual location and movement of electrons around an atom’s nucleus?

Answers

Because real electrons are in an electron cloud, not layers

the pressure of a sample of gas was 97.8 kPa and the volume of the gas was 3.75 l. if the gas occupied a container with a volume of 8.00 L, what would the pressure in the container be?

Answers

If the temperature stays the same then:
P1V1=P2V2 
so:
97.8*3.75=8P
366.75=8P
P= 45.84 kPa is the new pressure
Other Questions
A solution containing large amounts of solute in comparison to solvent is what?
Scientific Inquiry incorporates many scientific methods.A) trueB) false
In an engine governor, the two spheres (total mass of 1.0kg) are at 0.05m and rotating at 37rad/s If the engine increases the angular velocity to 58rad/s what is the new location of the spheres?
Edwin Hubble categorized galaxies according to theirA. shapes.B. colors.C. food supplies.D. inhabitants.