Which word best describes the degree of overlap between the two data sets?A.
high

B.
moderate

C.
low

D.
none

Answers

Answer 1

Answer: The right answer for the question that is being asked and shown above is that: "C. Low." The word that best describes the degree of overlap between the two data sets is low. The overlap is not that big enough or nothing at all. It is just low.

Related Questions

Josef ate 1/4 a pizza in 1/2 an hour. How much pizza would Josef eat in one hour?
The figure below shows a trapezoid, ABCD, having side AB parallel to side DC. The diagonals AC and BD intersect at point O.If the length of AO is three times the length of CO, the length of BO isone-third the length of ACone-third the length of ABthree times the length of DOthree times the length of DC
A square pool has an area of 292 square feet. To the nearest tenth, what is the length of one side of the pool? A. 8.5 feet B. 17.1 feet C. 73.0 feet D. 146.0 feet
Paige claims that the solution to the systems of linear equations y=2x-1 and -12x+3y=9 is (-2,-5). Which 3 methods could be used to verify Paige claim?
What is the formula for V=lwh for h

What is the value of j in the equation j + j + 14 = 3 j + 10?a. 2
b. 16
c. 2
d. 4

Answers

2j+14=3j+10
14-10=3j-2j
4=j D

good luck..

J is equal to four, because after you add all the j's up and subtract the un-needed ones, you get 4=j

What is named by a capital letter and has an exact location in space?A. point
B. line
C. line segment
D. ray

Answers

A.point

A point is represented by a dot and named by a capital letter.

Point is the correct answer.

Evaluate the expression when r = 8.2 and s = –3.7. r – 2s
a. –22.94
b. 0.8
c. 4.5
d. 15.6

Answers

When you plug in the numbers for the integers, you get
8.2-2(-3.7)
If you multiply -2 and -3.7, you get 7.4 because the negatives cancel each other out.
If you then add 8.2, you get 15.6. So the answer is D.
Hope it Helps! :)

HELP. I don't know if I'm supposed to put in theorems or?? It's a fill in the blank for a,b,c,d, and e.
Pretty sure A and B are "Given" but not 100%.

Answers

I hope this helps you

Which statement is true about a line and a point? A point and a line have length as a dimension to measure.

A point is a location and a line has many points located on it.

A line and a point cannot lie on the same plane.

A line and a point cannot be collinear.

2. Trisha drew a pair of line segments starting from a vertex.

Which of these statements best compares the pair of line segments with the vertex?

The line segments and the vertex have length as a dimension of measurement and there are three collinear points on each.

Line segments and the vertex have two endpoints each and the distance between the end points is their dimension.

Line segments have two endpoints and a vertex is a common endpoint where two line segments meet.

The line segments and the vertex have their lines extending in one direction only and the lengths of both are infinite.

Answers

1. The statement that is true about a line and a point is a point is a location and a line has many points located on it.
2. The statement that best compares the pair of line segments with the vertex is that line segments have two endpoints and a vertex is a common endpoint where two line segments meet.

Karen's favorite movie is 123.13 minutes long. Her second-favorite movie is 96.75 minutes long. How much longer is herfavorite movie?